Technology | If you want the outdoor LED display to not leak, you have to install it like this

If the LED display is used outdoors, it will face many challenges. The LED display screen will be affected by severe weather such as high temperature, cold wave, strong wind, rain, etc. If these aspects are not done well, the safe operation of the display screen will be impossible to talk about. Today, the editor will tell you how to install the LED display to prevent water leakage.

1.Add backplane to seal glue

In order to save trouble, many friends install outdoor LED displays without backplane or backplane without sealant. Over time, the electronic components will be flooded, and LED displays will have problems over time. Electronic components are most afraid of water. Once water enters the circuit, it will inevitably cause the circuit to burn. These problems that can be solved at hand must not be ignored.

2. Make leaking holes

If the LED electronic display and the back panel are tightly integrated, a leak must be made below; the so-called leak is used to leak water. No matter how tight the front and back of the LED display are combined, there is still more or less water inside the LED display over the years. If there is no leaking hole in the lower mouth, the water will accumulate over time. If the leaking hole is punched, the water will be If it flows away, it can have a good waterproof effect, and it is also good for extending the life of the LED display.

3. Appropriate circuit design

When installing an outdoor LED display, you must use a suitable wire for the plug connection. Generally, follow the principle of large and not small, that is, the total wattage of the LED display is calculated, and a slightly larger wire is used. It is best not to use just or excessive Small wires, it is easy to cause the line to burn, thereby affecting the safe operation of the LED display.

more articles:

Technology丨LED display automatic brightness adjustment core technology sharing

Sunrise LED Display manufacturer